Xhorse Dolphin XP007 Cannot Slide Workbench Solution

Problem: I had a problem with my Xhorse dolphin xp007 manual key cutting machine. Can’t slide back and forth, can only spin in circles. Any solution?

The workstation (Y direction) cannot slide or shake back and forth solution:

Step 1: Turn the device over. Check if there is something stuck in the sliding gap of the bottom rail.

If yes, clear dirty stuff

If no, do Step 2.

Step 2: Adjust the 2 Kimi screws on the right side against the guide rail, and move the cross slide back and forth. If the cross slide is smooth and not stuck, tighten the 8 screws immediately

NOTE:

Tip: If the 8 screws are loosened, do not tighten the 8 screws immediately. The 2 Kimi screws on the right side need to be adjusted to ensure that the cross slide moves smoothly before tightening the 8 screws.

Xhorse Program 2013 Subaru BRZ 93C86 Key via Dump

 How to use Xhorse VVDI Mini Prog to read 2013 Subaru BRZ EEPROM on an ECU certification module? It’s not allowed reading by pressure, but can work with EEPROM adapter. Following I’m gonna show the procedure.

Preparation

As you can see, this is the EEPROM MCU what I’m going to remove. I covered with aluminum foil so that the aluminum foil can absorb most of the heat.

It’s always very imperative and important that you mark position 1 on the chip until closest place on the board. Or you can remember where 1 is at. But on this board, it’s particularly right here where it says R074. There’s a little narrow pointing into pin number 1.

I’m gonna line it up into the XDNP10 EEPROM Adapter chip slot.

Read EEPROM Data

Go to Mini Prog app:

EEPROM and FLASH >> SEIKO >> S-93C86BD >> Read >> EEPROM >> Start operation

Press START button on Mini Prog.

Press “Save and edit”, we can see the data directly.

Save the file.

Data file path:

File management >> Local file >> Date >> File

Put the other key to VVDI Key Tool Plus or something tool like that, I can utilize that file. By uploading the file to Xhorse cloud so that my other devices can access it as well.

Key Programming

Immo programming >> Toyota >> Select by type >> Smart key system >> All smart remotes lost >> Generate emergency key >> OK >> OK >> OK >> My data >> Select data file >> Download >> Download here >> Save

Now I can load the file to generate a Subaru key with 78 type.

www.vvdishop.com

How to Fix No Xhorse App in Play Store?

Question: Does anyone know why the Xhorse app is not in the Play store? on Android the app does not appear. Or will they have it to share?

Answer:

Scan the QR code here to link your xhorse account if not find app in the Google play store.

For iOS system, directly search and download xhorse app on Apple google play store or download here,

https://apps.apple.com/us/app/xhorse/id1440550587

Can I Renew BMW PCF7944 Key with VVDI Mini Key Tool

 Need renew bmw keys, chip different, PCF7944, will xhorse vvdi mini key tool do it?

Solution:

This PCF7944 is the 1st generation of this type keys.
7944 can’t renew but can program to car by back door. Pcf7944 keys are cheap also.
This cheap can be fully read out, then its data can be successfully written to cas 2 or cas3
Use proper programmer to adapt to CAS.
But you need to remove CAS.