This is a quick demo on using Xhorse Dolphin II to copy a 2007 VW Jetta key blade. It’s a HU66 blade. As already prepared a new key blank here, let’s get to start.
Vehicle database >> Volkswagen >> Jetta >> A5-Typ 1K(After 2005)
Follow the tips to install M5 clamp, and rotate to side B.
Tighten the key shoulder align on clamp.
Press “OK”.
In general, I should decode the working key first.
But key bitting codes have been shown on Dolphin 2 screen: 12133422
It’s same as the working key.
So I’ll go to cut key directly.
Cut key >> Cut
Dolphin XP005L machine starts working.
Lay down the cover and wait for processing…
100%, cutting key completed.
Alright, I’m gonna brush off scraps and see how it did.
That’s kind of amazing, it looks pretty good.
Compare to the original key, they are same.
This is only one-side cutting, second side cutting can follow the same way. It’s smart & easy to cut 2007 VW Jetta key with Xhorse Key Cutting Machine. I don’t even have to decode.
Xhorse vvdi mini obd tool firmware can be updated via WiFi or PC. Here vvdishop.com shows how to update xhorse obd mini with PC. Fast and easy.
Software download
Download Xhorse Upgrade Kit here
Connect xhorse mini obd tool with PC via USB cable
Run Xhorse Upgrade Kit
Select MiniOBD device, Find device and run Upgrade
Wait until the update procedure is completed.
Xhorse VVDI Key Tool Plus Pad + BMW solder-free adapter have ability to program CAS4/4+ smart key on bench. No soldering in need, quick job in minutes. This will need to dismount CAS4 module from vehicle.
Tools required:
BMW CAS4 module
XDNP12GL BMW CAS4/CAS4+ Adapter
Backup CAS4 Data
Prog >> CAS4+(5M48H)-BACKUP >> Adapter
Read successfully.
With the data file, we’re ready for BMW key programming as wanted.
In addition to this, CAS4/CAS4+ welding-free adapter also supports reading by VVDI PROG + XDPGSOGL Cable. Same principle and convenience but different in tools.
2016 ram 1500 push start proximity fcc GQ4-54T remote programmed fine using xhorse vvdi mini key tool and xhorse smart remote.
First Attempt:
I generated the one that says dodge ram (Dodge-RAM 1500 2500 3500 prox)
Remote programmed fine using the xhorse mini key tool.
When programming it says put the new fob against the pts button then press and release unlock
Xhorse VVDI MB BGA Tool + Benz ECU Renew Cable can support renewing Mercedes ECU covering CR3.XX, XR4.XX, CR5, CR6, CR60.XX, SIM271DE2.0, SIM271KE2.0, SIM4LKE, CRD.11, CRD2.XX, SIM266, ME9.7, MED17.7X, etc. Easy done in 2 minutes.
Here’s taking Mercedes M271 ECU as a demonstration.
Disassemble ECU from vehicle, connect SIM4LKE adapter & VVDI MB according to ECU model.
Open VVDI MB software:
Click “Renew ECU/Gearbox >> Read”.
Click “Erase Pass.” to get the password.
Benz ECU info is showing:
Personalized: Yes
Activated: Yes
Click “Renew”.
Erase target unit success.
Let’s read ECU again at this time.
Benz ECU info has changed to:
Personalized: No
Activated: No
Benz E
That means done.
Renew Mercedes M271 SIM4LKE ECU is successful.