If you have a problem with Xhorse MB Smart keys. Cars would not recognize them, and sometimes they don’t run engine after programming.
On VVD MB click other functions, then Update MB Smart key
Set key frequency/upgrade smart key
1. Support specific manufacturer keys to change the key frequency through IR
2. Support the smart key of a specific manufacturer to upgrade to the latest version of the server through IR
Renew ecu Mercedes Benz edc16c2 with xhorse vvdi key tool plus on bench successfully. VVDI MB Tool can do the job as well.
Connect ECU with key tool plus via renew cable follow the wiring diagram
An extra power supply is required, keep voltage up to 12V
Go to Immo programming- Benz- Select from system- Engine/Gearbox/ISM function
Read ECU data
Save data
Select Renew function
Load HASH file
upload ecu data just read
confirm and continue
Press Get Erase password
Select Renew
Xhorse VVDI MB BGA Tool + Benz ECU Renew Cable can support renewing Mercedes ECU covering CR3.XX, XR4.XX, CR5, CR6, CR60.XX, SIM271DE2.0, SIM271KE2.0, SIM4LKE, CRD.11, CRD2.XX, SIM266, ME9.7, MED17.7X, etc. Easy done in 2 minutes.
Here’s taking Mercedes M271 ECU as a demonstration.
Disassemble ECU from vehicle, connect SIM4LKE adapter & VVDI MB according to ECU model.
Open VVDI MB software:
Click “Renew ECU/Gearbox >> Read”.
Click “Erase Pass.” to get the password.
Benz ECU info is showing:
Personalized: Yes
Activated: Yes
Click “Renew”.
Erase target unit success.
Let’s read ECU again at this time.
Benz ECU info has changed to:
Personalized: No
Activated: No
Benz E
That means done.
Renew Mercedes M271 SIM4LKE ECU is successful.
We may find that it is seldom used the VVDI MB Tool OBD Clip while programming Mercedes. In general, we more often use the OBD cable connector instead. So when and how to use the OBD clip?
When programming Benz 204/207 with directional lock on car, it’s not able to read data with VVDI MB Tool by OBD directly. That’s because data will be interfered due to OBD connection. That’s why locksmiths always remove directional lock on bench to read immo data or match simulator.
Can we program Benz 204/207 without wiring harness on car?
The answer is yes.
By reason of filtration and interference from other car modules, it’s failed to read immo data by OBD. But we can bypass the interference through connecting OBD communication line on device to directional lock straightway. That’s what the VVDI MB OBD Clip can do: connect to directional lock.
How to use VVDI MB OBD Clip?
Note:
* DO NOT disconnect plugs of directional lock & ELV Emulator.
* Clamp to the corresponding line for red marked pin.
* Need to break wire skin.
It’s recommended to use the way in case emergency without any EIS/ELV Test Lines.