How to Solve Opel insignia Xhorse Wireless Remote Not Working?

 Problem:

I’m programming an xhorse wireless remote key to Opel insignia, the car starts normally but the remote is not working. First generate the remote for opel id 46, then programming to the car.
program the transponder ID47 Opel as well. I’ve tried it with vvdi mini obd tool also from car menu but nothing, any idea?

Solution:

Finnaly the remote is working after programming by the mini key tool! For those that need information just follow these steps (just insignia, other model can be different)

Go to Vehicle Remote- Opel 433 281- Select from system – Immo system – Type 1

(1) . Close all doors, switch ignition on.
(2) . Input 4-digit PIN code.
(3) . Password is being verified, it takes no more than 5 minutes, please be patient……
(4) . Open then close the driver door, make sure all appliances are off, click [OK] to continue.
(5) . Please insert the wanted programming key, switch ignition to ON.
(6) . Current key is programmed successfully, click
[OK] to continue to program next one.
(7) . Please switch the ignition off and remove the key.
(8) . Open then close the driver door, make sure all appliances are off, click [OK] to continue.
(9) . Please wait for 45 seconds.
(10) . Switch ignition on

www.vvdishop.com

How to use XN002 remote to clone ID46 transponder

Here’s the little guide on how to snoop ignition data with the Xhorse XN002 wireless remote and clone an ID46 transponder chip using VVDI Key Tool remote generator.

Turn on your Xhorse VVDI Key Tool

Select Transponder Clone from main menu

Insert the original key into the left coil and press OK to read data

Press down arrow to start cloning the transponder

Select wireless Mode and insert the XN002 wireless remote into the left coil

Insert battery and put acquisition remote near vehicle ignition coil, switch on igntion 1 time, then put remote back to the Keytool induction coil, press OK to read data

Go to the car and place the XN002 xhorse wireless remote next to the ignition

Turn the ignition on to sniff the data

Insert the XN002 remote back into the left coil to get data

Insert the original key into the left coil for calculation

Insert the XN002 remote or an Xhorse ID46 chip into the left coil to finish the cloning process

VVDI key tool cloning ID46 remote success.

http://blog.vvdishop.com/use-vvdi-key-tool-xn002-wireless-remote-to-clone-id46/