Will Xhorse Generate Toyota Sienna BABA Remote

 Question: Possible to program Toyota Sienna 2021 proximity smart key with xhorse vvdi key tool plus? P4 page is BABA.

Answer: Add key ok, no possible to program all keys lost.

For add key, generate Toyota XM38 remote under this option. Then program xm38 remote with key tool plus. Key tool plus will ask for rolling code which you have to obtain from 3rd party.

Users can customize key frequency and buttons after programming.

Xhorse VVDI Key Tool Max Unlock BMW F Series HUF5662

 Here is showing how to unlock or renew a BMW F series HUF5662 smart key with Xhorse VVDI Key Tool Max. Certainly you can use the new VVDI Key Tool Max PRO instead. Simple operation, minutes to do.

This is the BMW locked key, it’s a transponder 49 PCF7953P chip.

Accessories Required

BMW Smart Key

VVDI Key Tool Max/ Key Tool Max PRO

Renew Cable

Operation

Take off the PCB.

Go ahead on Key Tool Max programmer:

Special function >> Remote renew >> BMW >> HUF5662 F Series 315MHz Huf

Here we can zoom in to check the connection diagram.

Solder the wires to PCB, then connect renew cable to Key Tool Max.

After completing soldering, press “Unlock”.

Unlock success.

Desolder the wires from PCB to read the transponder again.

As we can see, it’s unlocked now.

BMW key renew has been successfully done.

www.vvdishop.com

BSI Valeo PSA 912dg128A Pinout to VVDI Prog

 Where can i find pinouts to read bsi valeo psa with xhorse vvdi prog and which eeprom?

EEPROM:
912dg128A Motorola

Pinout to vvdi prog

Xhorse Dolphin II Peugeot HU83 Error Code 2 Solution

 Problem:

I had a problem cutting Peugeot 207 HU83 key blade with new xhorse dolphin xp005l key cutting machine. Giving Error code 2 probes not detected.

Solution:

The clip key is in the wrong position.

Pay attention to the position of the clip key, not in the bottom groove.
If the key clip is in working position you will fail to cut key (usually get error code 2)

www.vvdishop.com

Xhorse Dolphin XP008 Failed to Cut Key Solution

Problem:

My Xhorse Dolphin XP008 manual key cutter cannot cut this type of blade. Any solution?

Solution:Dolphin XP-008 is automatically tightened by this spring, the key blank is too thick and cut too hard.

Losen these two screws then tighten them again.

Try to cut key again.

If it does not work, remove this part and check if belt is loose.

www.vvdishop.com