Xhorse VVDI Key Tool Plus Pad can detect ignition coil to confirm whether the vehicle is equipped with chip & immo system when all keys lost.
How to detect vehicle ignition coil for AKL?
If Key Tool Plus Pad has no any response, which means the vehicle is not equipped.
Other Purpose
Mercedes W251 (w164 EIS with NEC) all keys lost xhorse vvdi key tool plus failed to calculate password (data acquisition failed). Autel IM608 cannot too (ZGW connected with EZS using GBOX).
This is a quick demonstration on using Xhorse Key Reader XDKR00GL + Panda XA-006 or Dolphin XP005/Dolphin II to read & cut a Honda Activa 5G key. Beyond that, Key Reader also supports connecting other Xhorse Key Cutting Machines or work alone. Let’s take a look how easy to operate it.
Connect to Panda key cutting machine firstly.
Optional identification >> Honda(Cycles) >> Activa 5G >> OK
Insert key blade vertically into Xhorse Blade Skimmer slot.
Identification >> Identification
Identification successful.
Bitting codes were shown on screen: 12112313
We can go on to cut key directly.
Install a blank key on clamp.
Cutting key >> Continue
Xhorse key cutting machine will start cutting automatically…
Cutting key completed.
Compare the new key to working key.
They are same.
New key can switch lock perfectly.
Done.
If you can hear the sound of the motor but Xhorse dolphin xp007 key cutting machine not working properly after turning on the power, you may need to disassemble the plastic case to check if the belt is broken and replace it if necessary.
Check the original box the machine came in. There is a spare replacement.
How to disassemble the dolphin xp007 plastic case?
How to disassemble the dolphin xp-007 motor bracket?
There are 2 ways to disassemble Xhorse Dolphin XP007 shell,
Method 1:
Method 2:
How to Replace the xhorse dolphin xp-007 belt?
https://www.vvdishop.com/service/replace-xhorse-dolphin-xp007-belt.html
Here we going to show how to duplicate a map wave key Honda HON66 with Xhorse Dolphin II XP005L key cutting machine.
Tap on Dolphin touch screen:
Vehicle database >> Honda >> All key blank >> HON66
It tells to use the M5 clamp side A, tip align 5th position.
Place the original key according to tips.
Let’s continue.
OK >> Decode key
Xhorse Dolphin 2 is going to start reading the bittings…
Decode key complete.
Once we have the bitting codes, remove the key to insert a new new one to cut.
Adjust it well to tip align 5th.
Cut key >> Cut
Dolphin 2 machine will start cutting…
Once finished, turn it over to cut the other side.
Simple operation are all the same.
Cutting key completed.
Remove the new key to insert lock for a test.
It turns perfectly and it’s same smooth as the original one.
HON66 key duplication has done.