Xhorse VVDI Prog Pinout to Nissan BCM 5M48H 1N35H

Here comes the Xhorse VVDI Prog wiring diagram pinout to Nissan Infiniti BCM 5M48H and 1N35H.

Nissan Infiniti BCM wiring diagram 5M48H -1N35H

Clone BCM module data.

In vvdi prog, select

2. microcontroller

Motorolla MC9S12 series

MC9S12XEP100 unencrypted.

Read EEPROM, DFLASH, PFlash and write all data to clone the BCM.

Clone VW Jetta EDC17CP14 ECU with Xhorse Multi PROG

 Xhorse Multi Prog VAG EDC17CP14 ECU cloning review:

Vehicle model: 2014 Volkswagen Jetta 2.0 TDI

ECM Clone

-Bosch EDC17CP14-

Bench Mode with 120ohm Resistor-Failed

Boot Mode-Success.

Read/Write Internal Flash-Success.

Read/Write Internal EEPROM-Success.

Checksum correction with multi prog success.

Tuning Protection & Immobilizer Disabled/IMMO OFF (Third Party).

Photos attached:

Xhorse MVCI Pro+ vs MVCI Pro J2534 Cable

Xhorse released a new MVCI Pro+ XDMVJP J2534 passthru cable in September 2025. What’s the difference between new MVCI Pro+ and the old MVCI Pro cable?

Difference:

Different cable design.

The old MVCI pro cable is an integrated design where the USB cable and the main unit cannot be separated, while the new MVCI Pro+ cable allows the USB cable and the main unit to be detached.

Indicator light status is different.

As for supported brands and software, they are identical.

Both cable supports following brands and software.

Software	Supported Brands
Xentry/DAS/DTS	Benz, Maybach, Smart
VIDA	Volvo
Consult3 Plus	Nissan
CLIP	Renault
Diagbox	Peugeot
Tech2win GDS2 RDS	GM group
ODIS	VAG
HDS	Honda Acura
SSM 4	Subaru
FDRS IDS	Ford
Mazda IDS	Mazda

Continuously adding new brands.

Xhorse Multi Prog Read Peugeot DCM6.2A ECU in Boot

Here comes the Xhorse multi prog feedback on PSA DCM6.2A ECU.

PEUGEOT DCM6.2A BIG IMPROVEMENT.
Write today another ecu from PSA DCM6.2A with multi prog, and see really HUGE improvement… some months ago when i write such of ecus it takes almost 15 minutes and i had and warning message from the tool.

but today it finished the writing in one and a half minute 1 min & 27 secs.

Checksum is done online with the multiprog.

Xhorse XDNP17 Porsche BCM Adapter Crack Failed Error Solution

 Problem:

Xhorse VVDI Key Tool Plus failed to read Porsche Macan 2015 BCM 5M48H using the XDNP17 Porsche BCM solder free adapter.

Error cracking failed: check the adapter and module connection. Chip crack Fail. Unknown error.

Any solution?

Solution:

Here are possible solutions:

1).

Check the jumper. Sometimes, if you put the jumper wrong, you will get this error.

2).

Had the same issue 1 time. Gotta clean off the connection points really good. To bare metal. Then make sure you are in the exact holes they are supposed to go into.

3). Try more attempts. If still has crack failed error, do as the key tool plus suggested. Try testing function 72 and 74 and report.