VVDI2 and Multi Prog Change VAG MQB 5A Cluster Mileage

 Xhorse Multi Prog and VVDI2 are possible to change the odometer for VAG MQB 5A cluster. You can read it for immo.

Besides being able to make lost keys (Read micro v850 and rh8505a), Odometer also works.

Example:

Mileage change rh850 5a
With multiprog.
Everything ok.

Original mileage 52,216 km

Desired mileage: 890km

Xhorse VVDI Key Tool Plus Add Skoda Octavia 2016 MQB Key by OBD

 Successfully added a spare key to Skoda Octavia III 2016 VRs MQB using Xhorse VVDI Key Tool Plus.

– Start to finish ~8min.
– KD ZB remote.
– All step obd.
– Remote sync needed after programming (driver door manual procedure).

VDO MQB35xx 2014-UDS
Chip type: D70F3537

Select Key Adding automatic wizard menu.

Step 1: Read and save eeprom
Step 2: Read and save immo data.
Step 3: Reset instrument, clear DTC, sync instrument time
Step 4: Generate dealer key
Step 5: Learn key

www.vvdishop.com

How to do Xhorse Key Tool Max Pro Self Test

 If your Xhorse VVDI Key Tool Max pro fails to start communication with vehicle and asks to check if the OBD wiring is normal, follow guide below to do a device self test.

VVDI Key Tool Max Pro Self Test

In main menu select IMMO Programming

Select More Functions

Press Device Test

Select K-line Test

Short Connect PIN7 and PIN15 with the OBD connector.

If Key Tool Max Pro says the test failed, there is something wrong with the device. You may need to send it back for repair.

https://www.vvdishop.com/service/vvdi-key-tool-max-pro-self-test.html

How to Cut VW Passat CC Plastic Key with Xhorse Condor

How to cut plastic car keys using Xhorse Condor XC-Mini Plus? The VW Passat/CC and old BMW all have plastic keys for emergency blade, so this is a very useful tip for locksmiths. You can follow the tip if you have any other Xhorse Key Cutting Machine.

*You can’t nornally just put the plastic key on clamp for direct decoding or cutting.

• You should LISHI the door or figure out the bitting codes at first.

• Then once you do that, put a metal key on the clamp and perform “Cut Key”. When the probe dedects it, pause Xhorse Condor machine right before it starts cutting.

• Change the metal key into plastic key and put it on the clamp.

• Hit “Cut” to continue key cutting. You can just repeat the same operation for the other side cutting.

That’s the key we cut it now. Let’s test it.

Yep, so it does work, it can open the door.

Done.

www.vvdishop.com

How to Clone Ford Focus BCM with Xhorse Multi PROG

 Ford Focus BCM cloning is done by Xhorse Multi Prog.

using this pinout

Ford Focus BCM 5M48H (MC9S12XEP768) wiring diagram

Read chip ID ok

Read D-flash and P-flash ok.

Write D-flash and P-flash ok.

www.vvdishop.com