برچسب vvdi2 - ابزار Xhorse VVDI

Program Audi A6 Q7 Allroad Dealer Key with VVDI2

Here’s the solution for Xhorse VVDI2 prepares Audi A6/Q7/Allroad 4th immobilizer dealer key successfully but fail to star car.

Reason: The step for key learning is skipped/wrong.
Solution:
please check guides below to to learn the key correctly.

Audi 4th Immobilizer system- Audi A6/Q7/Allroad
This type use MEGAMOS 8E transponder
If you want prepare a new dealer key, you must know the total 12 bytes CS.
But there’s only 6 bytes CS in ECU, so we need read the whole J518 EEPROM dump.

Read CS from ECU, only read 6 bytes CS and PIN. With 6 bytes CS and PIN help, VVDI2 can use OBD standard method to read/write EZS-Kessy EEPROM (J518), read/write VIN etc

Step 1: Autodetect from engine ECU
Step 2: Read and save EZS-Kessy EEPROM (J518)
Step 3: Load J518 eeprom dump file
Step 4: Make dealer key
Step 5: Key Learning

Note: OBD standard method only support 9S12DT128 type.
In J518 use 9S12DT128 chip (most cars before 2009 use this type).
But does not support J518 with 9S12DT(G)256 chip (most cars after 2009 use this type.)
That means 9S12DT(G)256 type doesn’t support prepare a dealer key with this method.

VVDI2 also can read J518 dump as service model what is only used for make normal dealer key, need to make sure which is chip model, VVDI will read wrong data if is no match, so first make sure what chip it is.
Remark:
Read dump with working key is only can be used for make normal dealer key, not for OEM key, neither for write back to KESSY.

Step 1: Read J518 EEPROM Dump with working key
Step 2: Load J518 eeprom dump file
Step 3: Make dealer key
Step 4: Key Learning

http://www.vvdishop.com/service/how-to-program-audi-a6-q7-allroad-dealer-key-with-vvdi2-9092.html

vvdi2 vvdi2 vag

Emily جمعه 16 فروردین 1398 ساعت 13:51

0 نظر

Which VVDI tool for Mini Cooper key programming?

What Xhorse tool can you get for programming mini cooper?

VVDI KeyTool? That’s not for programming.

VVDI Key Tool is chip cloning, chip generator, frequency tester, remote generator dan can reset some used remote/smartkeys to the virgin state.

You need VVDI2 for key programming.

But from what i learn from many friends in many forums it’s quite good for BMW Mini Cas 1, 2, 3, 3+ and may be 4.

As far as i know most of them can be done via OBD (with the exception Cas 3+ in which you need to back up the Cas first by reading it on bench – needed VVDI Prog) but in case you are not really so sure make back up first.

We don’t do BMW or European cars here (not so often). Most of the time we deal with Japan cars.

Look here: how does Xhorse VVDI2 BMW program a new key to mini cooper

Car: Mini Cooper Hatch 3 2018

System: FEM / BDC system from BMW

Tip: How to know yours is CAS4 or FEM?

Method: on the table

Steps:

There are 5 steps to program FEM/BDC key:

http://blog.vvdishop.com/vvdi2-bmw-program-mini-cooper-hatch-iii-2018-bdc-key/

Attention please!!!

– You can directly backup/restore coding

– You have to pre-setup the FEM/BDC module before deleting/adding keys or resetting keys

– You’ll be told other tools need to be used first to program the FEM/BDC system, then setup FEM/BDC via VVDI2. It happens when you do FEM/BDC key learning, and you don’t have a working software version

– You’d better not close the VVDI2 interface when you pre-setup FEM/BDC

– You need do with 95128(FEM) or 95256(BDC) chip when pre-setup FEM/BDC

Note: there are two 8-pin chips; do not disassemble the wrong chip; better refer to the wiring diagram

– You must restore original EEPROM data, restore coding when pre-setup FEM/BDC. If you fail to restore coding or the remote cannot start or something wrong with the window (or other failures probably) after coding restore and FEM/BDC installation, please use other tools to do re-coding FEM/BDC

– Ask tech support @vvdishop.com for help, if the replay sounds continuously after supplying power to the FEM/BDC. Usually, it needs programming.

vvdi2 vvdi2 bmw vvdi key tool

Emily چهارشنبه 29 اسفند 1397 ساعت 09:19

0 نظر

Mitsubishi Outlander 2007 all key Lost programming with VVDI2

New test report from VVDI user:

Mitsubishi Outlander 2007 all key Lost super fast with Xhorse VVDI Prog and VVDI2 programmer.

Read and save dump 24C16 by vvdiprog

In Immo data tool, file make key by VVDI2

http://blog.vvdishop.com/program-mitsubishi-outlander-2007-all-key-lost-with-vvdi-prog-vvdi2/

vvdi2 VVDI Prog

Emily پنج‌شنبه 16 اسفند 1397 ساعت 13:13

0 نظر

How to share ID48 96bit license to VVDI2 and Keytool

If you have Xhorse VVDI2 with COPY 48 96 bit licence , you can share this service to vvdi key tool
Open Xhorse Upgrade Kit , select device you connect to PC, click DETECT and after detected click BIDING

New window will be open in website browser
Please login via Phone number or mail (use this same what you use when you register)
if you not register, please register your device