How to Fix Xhorse Dolphin XP008 Sounds Weird

 One of our customers reported that his Xhorse Dolphin XP008 manual key cutting machine sounds weird when duplicating key.

Here is the possible solution from Xhorse engineer.

1.Unscrew these two screws and take off the belt.

2. Unscrew 5 screws on the shell

3. Unscrew the top screw in this hole.

4. Unscrew the cutter head and you can take out the bearing

5. You can apply some glue on these two bearings, it must be a thin layer.

Install machine again, then try to cut key.

www.vvdishop.com

Xhorse Dolphin XP008 Failed to Cut Key Solution

Problem:

My Xhorse Dolphin XP008 manual key cutter cannot cut this type of blade. Any solution?

Solution:Dolphin XP-008 is automatically tightened by this spring, the key blank is too thick and cut too hard.

Losen these two screws then tighten them again.

Try to cut key again.

If it does not work, remove this part and check if belt is loose.

www.vvdishop.com